【摘要】 目的 研究使用Bowtie濾線器（F1）后，保證加速器CBCT患者掃描圖像質量前提下，如何合理設置掃描條件，盡量降低輻射劑量?！》椒ā∈褂肞iranha輻射測量?jī)x測量CBCT在使用F1與未使用F1時射線的半價層。設定不同的掃描模式，使用直徑30 cm的有機玻璃模體測量掃描劑量，并使用XVI附帶的Catphan503模體測量客觀圖像質量。在此基礎上，研究掃描劑量以及圖像質量與掃描條件的關系，提出了適合臨床患者的胸部與腹部不同的掃描條件?！〗Y(jié)果 使用F1后射束的半價層增加了0.77～0.92 mmAl，掃描劑量明顯減少，中心點減少了22%~29%，邊緣點減少了41%~45%，皮膚劑量減少顯著。圖像質量隨著掃描劑量的增大而提高。空間分辨力受FOV影響較大，但一般能識別1～2 mm的物體，完全能夠滿足分辨細小骨結構與標記點的臨床要求。圖像偽影在使用L20時的大mAs下明顯。胸部低劑量的CBCT圖像如100 kV，M20，0.5 mAs的掃描條件亦可滿足臨床要求。腹部則需要使用較大劑量的掃描模式，CBCT圖像才達到進行配準的要求?！〗Y(jié)論 F1的使用在改善圖像質量的前提下降低了掃描劑量，使用新的掃描序列能平衡二者的關系。【Abstract】 Objective To explore the influence of bowtie filtration on absorb dose and half-value layer inaluminum (Al) of cone-beam CT, estimate the image dose under different scan protocol, and establish the relationship between the image quality and the scan protocol after using F1. Methods Piranha was used to measure the HVL. Dose measurements were performed with an 0.6 cc Farmer type ionization chamber with a 30 cm-diam cylindrical shaped water phantoms in 100 and 120 kV with a series of mAs and FOV. CNR, noise and uniformity were measured on the Catphan503 images. Results HVL increased 0.77-0.92 mmAl where XVI generally had more penetrating beams at the similar kV settings. Scanning dose significantly reduced, the center point decreased 22%-29%, the edge with a decrease of 41%-45% which meant a very significant reduction in skin dose. Image quality improved with mAs increase. The spatial resolution mainly changed with FOV. But generally can identify 1-2 mm-diam objects, fully meet the clinical requirements of identify small bone structure and marker. Through this clinical investigation, low-dose CBCT images in chest, such as 100 kV, M20, and 0.5 mAs scanning protocol appeared to be an optimal settings. Abdomen image needed a higher dose to reach the requirements of registration. Conclusion Using F1 under the premise of improving the image quality then reducing the scanning dose and using a new scanning sequence can balance the image quality and scanning dose.
【摘要】 目的 分析重力因素對二維探測器陣列驗證靜態調強計劃的影響，判斷機架角度歸為0°的測量方法是否安全可靠?！》椒ā≡?°機架角和實際治療機架角分別測量靜態調強計劃的劑量分布，以3 mm范圍內偏差lt;3%(3% 3 mm)標準進行γ分析，獲得相對于參考劑量分布的通過率，分析通過率變化規律。分析兩種方法測量的等中心點絕對劑量的差異。 結果 通過率的變化呈隨機分布，96.9%的照射野偏差lt;2.5%。所有計劃的85.7%絕對劑量偏差lt;2%，最大偏差為4.75%?！〗Y(jié)論 使用二維探測器陣列在0°角進行調強計劃的日常驗證是安全可靠的。【Abstract】 Objective To analyze impacts of gravity on the verification of IMRT plans with 2-Dimensional detector arrays and to evaluate the reliability of the measurements in vertical direction (gantry angle=0). Methods The dose distributions for each beam in IMRT plans were measured with 0 degree gantry angle and actual gantry angle respectively. The γ percentage pass rate (according to 3% 3 mm) for each beam under each angle condition was obtained by the comparison between the measured dose distribution and the calculated dose map from the treatment planning system which was treated as the reference distribution. Then the absolute dose at the isocenter for each plan was measured at each angle condition and was analyzed. Results The variations of γ percentage pass rates between the two types of measurements were randomly distributed, and the deviations for 96.9% beams were less than±2.5%. The differences between absolute doses for 85.7% beams were less than±2% and the biggest deviation was -4.75%. Conclusion Verification of IMRT plans for the radiotherapy quality assurance using 2-Dimensional detector arrays in 0 degree gantry angle is safe and reliable.